e-Spinner 3
- Regularly apply a drop of oil to the front flyer bearing and bobbin bearings.
- If the flyer vibrates at high speed move the yarn guides so they are opposite each other.
- If the red light is flashing short on/long off, this indicates the 12v power pack is under load. Reduce the tension on the brake band. Ideally the springs should just start to stretch but never more than their own length.
- If the motor is hot after extended use, reduce the tension on the brake band. Ideally the springs should just start to stretch but never more than their own length.
- If the brake band wears out replace it and reduce the brake band tension. Ideally the springs should just start to stretch but never more than their own length.
- Check that the groove in the bobbin whorl is smooth and “U” shaped. If worn, rough or has a build up of lacquer, sand it smooth with fine sandpaper.
e-Spinner Super Jumbo
- When not in use, release the tension on the stretchy drive belt by moving it to the smaller bobbin whorl.
- If the flyer doesn’t spin freely, loosen the leather brake tension knob completely and remove the leather brake from the flyer. Apply a drop of oil to the front and back bearings and give the flyer a spin.
- To give an even yarn take up, apply a drop of oil to the flyer shaft and replace the leather brake. Only increase the leather brake tension if the yarn doesn’t pull in.
- If the red light is flashing short on/long off, this indicates the 12v power pack is under load. Reduce the tension on the leather brake.
- If the motor is hot after extended use reduce the tension on the leather brake.
